KIT_A2G_TC397XE_TRB

• Infineon’s TC397XE AURIX™ 2G ( TC3xx ) Controller in LFBGA-292 Package
• FlexRay™
• Transceivers
• High Speed CAN Transceivers (CAN-FD capable) 
• USB to UART bridge – Ethernet Gigabit PHY
• Serial Eeprom 
• LIN Transceiver 
• Crystal 20MHz (default) or External Clock
• USB miniWiggler JDS for easy debugging
• 8 Low Power Status LEDs
• 8-DIP switches for configuration
• access to all pins of controller
• 100mm x 160mm (EURO-Board)
• Infineon’s LIN-Transceiver  TLE 7259-3GE
• USB to UART bridge FT2232HL (FTDI)
• Integrated 10/100/1000M Ethernet Precision Transceiver RTL8211FI-CG (Realtek)
• 8 general purpose LEDs
• 2K I 2C Serial Eeprom with EUI-48™  Node Identity (MICROCHIP)
• Reset switch
• Enable switch
• Generic switch
• 4-pin Dip switch

Connectors:

The TC3X7 TriBoard offers a wide variety of connectors:

• Standard power connector
• Micro USB connector for ASC Interface (ASC0) and miniWiggler
• RJ45 connector for Ethernet
• 16-pin header for JTAG interface (OCDS)
• 3 x 10-pin header for DAP, DAPE and DAP_SCR (DAPE only usable on Emulation Device)
• 10pin (2x5) Header for LIN Transceiver (LIN)
• 2 x 10pin (2x5) Header for CAN High Speed Transceiver (CAN0 and CAN1)
• 2 x 10pin (2x5) Header for FlexRay™ (ERAY-A and ERAY-B)
• four 80-pin connectors (male) + four 80-pin connectors (female) with all I/O signals
• optional ETK connector
• optional 2 x 6pin (IEEE1394) Socket for HSCT
• optional Aurora connector (only with Emulation Device)

Components:

• Infineon’s Multi Voltage Safety Micro Processor Supply TLF35584QV
• Three LEDs to validate power supply (5Volt / 3,3 Volt / 1,25 Volt)
• LED indicating safe state signal 2 from TLF35584
• LED indicating /HDRST (ESR0) active state
• LED indicating activ miniWiggler JDS
• LED switched via DAS software
• 2 x Infineon’s FlexRay™ Transceiver TLE9221SX
• 2 x Infineon’s High Speed CAN-Transceiver  TLE9251VSJ